Instruction manual

To open the Administrator’s Mailbox:

1. Call the CLASSIC MAIL system by pressing an Voice Mail labeled outside line

button and enter the CLASSIC MAIL system access code.

2. Enter the administrator’s mailbox number and password. Your recorded this

information previously on the Appendix A, Installation Data Form.

A status message, "You have no new messages." plays.

(Assuming this mailbox is empty.)

3. For system setup

4. Enter the administration password (initially 0000).

(This is a different password than the Administrator’s Mailbox

password entered in step 2.)

A series of instructions beginning with, "To record

company greetings, press one... " plays.

Press

Note:

This procedure is later referred to as "Entering Administration Mode. " Use this procedure each

time you want to gain access to the CLASSIC MAIL system’s customization instructions.

Chapter 6: Customizing Basic Operations