Instruction manual

2
3
Reset the Line Configuration. See Chapter 9.
Perform Test 6. This test requires that you be familiar with the CLASSIC MAIL
system procedures for leaving and listening to messages. Refer to the CLASSIC
MAIL System Mailbox User Guide.
Note: Most Merlin systems are installed with the attendant’s or operator’s telephone cabled to voice
terminal jack 10 (or 0). Moving the voice terminal cable from jack 10 will essentially assign a new intercom
number to your attendant's telephone. As a result, after moving this cable, you must reassign the CLASSIC
MAIL system attendant intercom number to match this new intercom number, otherwise the CLASSIC MAIL
system Transfer Caller to Operator feature will not work properly. See Chapter 7, "Changing the Attendant 's
Intercom Number", for instructions.
TEST 6
1. Delete all messages in the attendant’s mailbox.
2. Leave a message approximately ten seconds long in the attendant’s mailbox.
3. Verify that the message light on the attendant’s telephone turns on within 90 seconds. The
attendant must have a telephone message light for this test.
4. Delete the message.
5. Verify that the message light on the attendant’s telephone turns off within 90 seconds.
If this test fails, turn to Chapter 10, Troubleshooting.
CLASSIC MAIL System Reference Guide
Part 1: Installing the CLASSIC MAIL System