Instruction manual

During this step you will temporarily disconnect some of your telephone lines. This

will interrupt your telephone service for several minutes. Consider doing this step

outside your normal business hours or during non-busy calling periods. To prevent

an accidental disconnection of calls in progress, verify that none of your outside

lines are in use before beginning.

If you have more than two outside lines, it is preferable to connect the CLASSIC MAIL

system to the two least busy lines; this makes retrieving messages a little easier. The

instructions below assume that your least busy lines are those plugged to outside line

jacks C and D on your Merlin Control Unit.

Note:

If you decide to connect the CLASSIC MAIL system to lines other than those plugged into jacks C

and D, follow the instructions below, substituting the line designators for these different lines in place of

line designators C and D.

CLASSIC MIAL System Reference Guide

To connect outside lines to the CLASSIC MAIL system:

Unplug the outside line that is plugged into the line C jack of your Merlin Control

Unit. See Figure 3B. If you have a Merlin Plus Control Unit, see Figure 3C.

Plug this line into the outside line 1 jack of the CLASSIC MAIL system. See Figure 3B

or 3C.

Unplug the outside line that is plugged into the line D jack of your Merlin Control

Unit.

Plug this line into the outside line 2 jack of the CLASSIC MAIL system.

Part 1: Installing the CLASSIC MAIL System