Instruction manual

Chapter 2: Getting Started

Getting started requires that you gather some information about your Merlin

Control Unit. Remove the Control Unit’s front cover, if it has one. Figure 2A shows

the various types of Control Units.

Completing the Installation Data Form

Record your information on the Installation Data Form in Appendix A. If you are

installing a CLASSIC MAIL system with a Merlin 1030/3070 Control Unit, skip the

instructions that immediately follow. Instead, use the "Installation Data Gathering"

instructions in the "CLASSIC MAIL System Control Unit Upgrade Kit Installation Guide."

The information you gather will determine if any of several installation options

apply to your installation. If no options apply, follow the instructions in Chapter 3

for a standard installation. If any options do apply, the Installation Data Form will

refer you to specific sections in Chapter 4, "Additional Installation Options."

Note:

Do not attempt to install any of the options described in Chapter 4 until you have read the

Instructions describing a "standard installation" in Chapter 3.

To complete the form:

1. Determine the type of Merlin Control Unit you have. See Figure 2A. Record this

information on the Installation Data Form.

Chapter 2: Getting Started