Instruction manual

3.
4.
5.
6.
7.
Verify that the numbered line button assignments of this telephone correspond exactly to
those shown in Figure 10A. (If you have installed the CLASSIC MAIL System Control Unit
Upgrade Kit for Merlin 1030/3070 Control Units, use the figure on the right.) Test each line
button, and the Transfer button (if your Control Unit has this feature) for proper operation.
If the button assignments do not correspond to those shown, reprogram the voice terminal
to reflect the proper assignments. Consult your Merlin System Reference Manual for
instructions on reprogramming voice terminal button assignments.
Remove the Merlin telephone and reconnect the telephone emulation cable to the CLASSIC
MAIL system’s telephone emulation jack.
Repeat this procedure for each telephone emulation cable installed.
Turn the CLASSIC MAIL system off, then on. See second note below.
Notes: Anytime you change the outside line, or interposed line cabling, you must reset the line configuration.
This means that if you permanently add or remove any outside lines to your control unit, or interposed line
cables connecting the CLASSIC MAIL system to the Merlin Control Unit, you must reset the line configuration.
If you temporarily unplug any telephone emulation cables, you should turn the CLASSIC MAIL system off then
on, to re-initialize the telephone emulation ports.
If you have a Merlin system with Feature Package 1 or 2, or if you have a Merlin Plus system, the CLASSIC
MAIL system will aulomatically program all its telephone emulation ports to operate with the Merlin “Do Not
Disturb’’ and “Privacy” features turned on. This will cause the CLASSIC MAIL system’s telephone emulation
ports to always appear busy on Merlin telephone auto-intercom lights.
Chapter 10: Troubleshooting
107