Instruction manual

2.
To change Control Unit integration parameters
press
3.
To change the Control Unit type
press
4. The report describing the Control Unit type and
software feature package type plays.
5. To change the Control Unit type
press
6. To change the Control Unit software Feature Package type
press
Changing the Call Transfer Type
You can determine the method that CLASSIC MAIL system will use when automati-
cally routing incoming calls to intercom destinations by changing the call transfer
type. Normally the CLASSIC MAIL system will be set to transfer incoming call
directly to an intercom using the Control Unit’s “transfer” feature. When the
CLASSIC MAIL system is set to use its direct transfer feature, transferred calls will ring
the destination intercom until answered. This method works only on Control Units
that support the transfer feature.
The other alternative is to use the “announced transfer” method. Using this method,
the CLASSIC MAIL system will put the caller on “hold” and announce the call over
the destination intercom. You will hear the call announced as, “Please pick up your
call on line... ”
You then answer the call using the outside line buttons on your
telephone. Do not use is method unless you have all outside lines appearing on all
telephones, and all outside lines appear on all telephones in the order shown in
Figure l0A.
Chapter 9: Other Administration Items
99