Instruction manual

To reset the line configuration and Control Unit type:
System Reference Guide
1. Enter administration mode
2.
To change Control Unit integration parameters
press
3.
To reset the line configuration and Control Unit type
press
4. Turn the CLASSIC MAIL system off, then on.
Note: Your Control Unit should be idle while the Reset Line Configuration process is underway. If not,
some lines may not initialize properly. Always check the results of this process by checking each line‘.s
status after you have reset the line configuration. To check line status, see the previous section,
“Changing the Line Configuration.”
Changing the Control Unit Type
If you want to hear a report describing the type of Control Unit that the CLASSIC
MAIL system thinks it is connected to, or if you want to change the Control Unit type
because it does not match your actual Control Unit, follow the procedure below.
(This menu item will not be available if you have installed the CLASSIC MAIL
Control Unit Upgrade Kit.)
To change the Control Unit type:
1.
Enter administration mode
Part 2: CLASSIC MAIL System Administration