Installation guide

Administration Procedure
Assign System Speed Dial codes to telephone
numbers and account numbers.
Assigning or removing a voice terminal from a
paging group.
Set the Transfer Return Interval.
Do This
1
2
3
4
5
6
Enter administration mode.
Dial the code (#60 through #89 or #900 through #999) you are assigning to
the number.
Dial either:
*90 to assign the code without Restriction Override
*92 to assign the code with Restriction Override
*88 to assign the code to an account number.
Dial the telephone number or account number.
NOTE:
To designate a telephone number as private (not printed on call
reports), dial * before the number in step 4.
If the telephone number or account number has the maximum allowed
16 digits, the console beeps twice when you enter the sixteenth digit.
Touch Administer.
The console beeps twice.
Leave administration mode.
1
2
3
4
5
Enter administration mode.
Dial the code for the paging group (*71 or *72).
Touch the Auto Intercom button or dial the appropriate code from the dial
code chart for the phone you want to add or remove.
Green light on = telephone is assigned
Green light off = telephone is removed
NOTE: Touch DROP to remove all voice terminals from a paging group.
Touch Administer.
The console beeps twice.
Leave administration mode.
1 Enter administration mode.
2 Dial the code for the transfer return interval you want (up to nine rings):
*2 plus the number of rings wanted (*25 = five rings).
*20 for transferred calls to not be returned.
3 Touch Administer.
The console beeps twice.
4 Leave administration mode.
(continued)
Quick Reference Guide to System Administration
3-41