Manualshelf

Installation guide

ManualsBrandsAT&T ManualsCommunicationMerlin
81828384858687888990
CALL RESTRICTIONS
For those voice terminals with a check mark in the “Disallowed List” column on
ASSIGNMENT FORMS
the form, follow the procedure below:
1 Enter administration mode.
The red lights go on next to Administer and Restrict.
2
Dial *0900.
3 Follow the appropriate procedure below:
NOTE: To assign the Disallowed List to all voice terminals, touch
Conference.
> Touch the Auto Intercom button for the voice terminal you want to assign
the Disallowed List.
The green light goes on next to the Auto Intercom button.
> Dial the appropriate code from the Dial Code chart located earlier in this
section under the heading “The BIS-22 Voice Terminal Used as an
Administrator Console” for the voice terminal to which the Disallowed
List is to be assigned.
4 Touch Administer.
The console beeps twice.
5
Continue to administer the system, or leave administration mode.
For those voice terminals with a check mark in the “Unrestricted” column on the
form, you don’t have to do anything here because when your system is first
installed, all voice terminals are unrestricted.
Check marks in the “Toll Restricted” and “Outward Restricted” columns show
the type of restriction you want to place on the voice terminal.
To assign either outward call restrictions or toll call restrictions to voice
terminals, follow the procedure below:
1 Enter administration mode.
The red lights go on next to Administer and Restrict.
2
Follow the appropriate procedure:
> Touch the Auto Intercom button of the voice terminal you want to
restrict.
> Dial the intercom number of the voice terminal you want to restrict.
3 Touch Restrict until the green light next to it shows the kind of call
restriction you want the voice terminal to have:
Steady green light on = Unrestricted (all talk permitted)
Flashing green light = Toll restricted (local and intercom calls only)
Green light off
=
Outward restricted (intercom calls only)
4
Touch Administer.
The console beeps twice.
5
Continue to administer the system, or leave administration mode.
3-34 Systemwide Options