Installation guide

5 Repeat the procedure for each line you are administering.
6 Touch Administer.
7 Continue to administer the system, or leave administration mode.
Remote Line Access (RLA)
If there is an “I” entered in this row, perform the following procedure to
administer the incoming Remote Line Access line group:
1 Enter administration mode.
The red lights go on next to Administer and Restrict.
2
Dial *54 for the Remote Line Access incoming line group.
3 Touch the line buttons until the green lights show the assignments you
want.
Green light on =
line is assigned to RLA
Green light off =
line is not assigned to RLA
4
Touch Administer.
The console beeps twice.
5
Continue to administer the system, or leave administration mode.
If you entered a number other than 2 in the “Ring Interval” column for RLA,
follow the procedure below to change the ring interval for
incoming RLA calls:
1 Enter administration mode.
The red lights go on next to Administer and Restrict.
2
Dial *763 plus the number of rings (0 through 9).
NOTE: If 0 is selected, the voice terminal will not ring, and calls will be
answered immediately.
3 Touch Administer.
The console beeps twice.
4
Continue to administer the system, or leave administration mode.
To use RLA, you must assign a 5-digit password (the first two digits are the
caller’s intercom number) to gain access to the system from a remote
location. You also need this password when changing the call forwarding
destination number when off-site.
To assign the password, follow this procedure:
1 Enter administration mode.
The red lights go on next to Administer and Restrict
2
To create a password for a particular intercom number, dial the intercom
number plus any three digits except 000.
3 Touch Administer.
The console beeps twice.
4
Continue to administer the system, or leave administration mode.
Line Assignments for Voice Terminals
3-31