Installation guide

Direct Extension Dialing (DXD)
If there is an “I” entered in this row, perform the following procedure to
administer the incoming Direct Extension Dialing line(s):
1 Enter administration mode.
The red lights go on next to Administer and Restrict.
2
Dial *58 for the Direct Extension Dialing incoming line group.
3 Touch the line buttons until the green lights show the assignments
you want.
Green light on =
line is assigned to DXD
Green light off =
line is not assigned to DXD
4
Touch Administer.
The console beeps twice.
5
Continue to administer the system, or leave administration mode.
If you entered a number other than 2 in the “Ring Interval” column for
Direct Extension Dialing, follow the procedure below to change the ring
interval for incoming DXD calls:
1 Enter administration mode.
The red lights go on next to Administer and Restrict.
2
Dial *761 plus the number of rings (0 through 9).
NOTE:
If 0 is selected, the voice terminal will not ring, and calls will be
answered immediately.
3 Touch Administer.
The console beeps twice.
4
Continue to administer the system, or leave administration mode.
If you put a telephone number in the column headed “Modify Message” for
DXD, follow the procedure below:
1 Enter administration mode...
The red lights go on next to Administer and Restrict.
2
Dial *50.
3 Touch the line button for the line on which you want to hear the
modified message.
The green light goes on.
4
Dial the telephone number you want to include in the message.
NOTE: For special phone numbers, such as 800 numbers, you may
prefer to have the recorded voice pronounce the number as
“Eight hundred” followed by the number, instead of “Eight, zero,
zero.” To do this, touch Hold to enter a pause after the toll prefix
and again after the 800 area code and then again after the
exchange. For example, 1-800-555-1212 would be entered as:
1 Hold 800 Hold 555 Hold 1212.
3-30 Line Assignments for Voice Terminals