Installation guide

4 Dial the telephone number you want to include in the message.
NOTE:
For special phone numbers, such as 800 numbers, you may prefer to
have the recorded voice pronounce the number as “Eight hundred”
followed by the number, instead of “Eight, zero, zero.” To do this,
touch Hold to enter a pause after the toll prefix and again after the
800 area code and then again after the exchange. For example,
1-800-555-1212 would be entered as:
1
Hold 800 Hold 555 Hold 1212
5 Repeat the procedure for each line you are administering.
6 Touch Administer.
7 Continue to administer the system, or leave administration mode.
If you put a “0” in the column headed “Modify Message” for CF, follow this
procedure to turn off the voice message:
1
2
3
4
5
Enter administration mode.
The red lights go on next to Administer and Restrict.
Dial *30.
Dial 0 to turn off the message.
NOTE: To turn on the message, dial 1 instead of 0 in step 3.
Touch Administer.
The console beeps twice.
Continue to administer the system, or leave administration mode.
To enter or change the call forwarding destination number from the
administrator console, use the following procedure:
1 Enter administration mode.
The red lights go on next to Administer and Restrict.
2
Dial *53.
3 Dial the destination number.
4 Touch Administer.
The console beeps twice.
5
Continue to administer the system, or leave administration mode.
Line Assignments for Voice Terminals
3-29