Installation guide

5 If you want to change the order in which the system selects available lines for
this telephone, assign an Automatic Line Selection sequence.
a While in programming mode, dial **.
b Touch the line buttons in the order you want them to be selected.
c When you are finished programming the basic telephone, slide the
T/P switch to the center position.
6 If you want the basic telephone not to ring on specified lines, use the Ringing
Options feature. While in programming mode, touch the line for which you
want to program a ringing option:
a If you don’t want the phone to ring, dial *35.
b If you want the phone to ring immediately when a call comes in, dial *37.
7 Disconnect the substitute voice terminal and connect the BTMI to the same
voice terminal jack. Then connect the basic telephone to the BTMI.
PROGRAMMING
None
HOW TO USE
A person using a basic telephone must dial the codes shown in Figure 6-1 to
access the lines the system administrator assigns to the intercom number for the
telephone.
FIGURE 6-1 Basic telephone codes for accessing lines.
❑ ❑
❑ ❑
884 889
❑ ❑
❑ ❑
883
888
❑ ❑
❑ ❑
882
887
❑ ❑
❑ ❑
881
886
❑ ❑
❑ ❑
880
Conference
Transfer
Drop
Hold
6-6 Accessory Equipment