Installation guide

3 Perform one of the following procedures:
> Touch the Auto Intercom button of the voice terminal that you are
administering.
Green light on = the voice terminal is locked.
Green light off
= programming can be done from the voice terminal.
> If You don’t have an Auto Intercom button for the voice terminal, then use
the corresponding dial code from the chart below:
If the intercom
If the intercom
number is:
Dial this code:
number is: Dial this code:
Intercom 10
#22 Intercom 20 #03
Intercom 11
#21 Intercom 21 #04
Intercom 12
#20 Intercom 22
#05
Intercom 13
#19
Intercom 23 #06
Intercom 14
#18 intercom 24
#07
Intercom 15
#17 Intercom 25 #08
Intercom 16
#16 Intercom 26
#09
Intercom 17
#15 Intercom 27
#10
Intercom 18
#14
Intercom 28
#11
Intercom 19
#13
Intercom 29
#12
4 Touch Administer.
The console beeps twice.
5
Leave administration mode by sliding the T/P switch to the center position.
T P
Auto
Intercom
Administer
89
T P
Administer
If you want to lock the programming function on all the voice terminals in your
system (except the administrator/attendant console connected to jack 10):
1 Enter administration mode by sliding the T/P switch to P and touching
Administer.
2 Dial *89.
3 Perform one of the following procedures according to whether you want to
lock or unlock the programming function at all the voice terminals in
your system:
> Touch Conference to lock every voice terminal in your system.
A green light goes on next to the Auto Intercom button corresponding to the appropriate
voice terminals. The voice terminals are locked; they cannot enter programming mode.
> Touch Drop to unlock all voice terminals in your system.
A green light goes off next to the Auto Intercom button corresponding to the appropriate
voice terminals. The voice terminals are unlocked; they can enter programming mode
when necessary.
5-118 MERLIN Plus System Features