Installation guide

PROGRAMMING
To program an Outside Auto Dial button for your voice terminal:
1 Label the button with a name and/or a number.
2 Slide the T/P switch to P.
The voice terminal rings every 5 seconds to remind you that you are programming and that
you cannot place or receive calls.
3
Touch the button you want to program.
4 Dial *90 plus a telephone number or a PBX or Centrex code (if you need to
include a special character in the dialing sequence, use the directions above).
5 Slide the T/P switch to the center position.
T P
T P
Home
Office
90
tel. no.
HOW TO USE
To dial an outside number with one touch:
1 Without touching Speakerphone or lifting your handset, touch the Outside
Auto Dial button for the number you want to dial.
Your voice terminal speaker goes on, and you hear dialing.
2
If you programmed the special character STOP in a dialing sequence, after
you hear the second dial tone, touch the Outside Auto Dial button again to
continue the dialing.
3 When you hear the other person answer, start speaking or lift your handset
then start speaking.
Home
Office
If the line is busy or if no one answers:
1 Touch Speakerphone or hang up to cancel the call.
Speaker-
phone
5-106 MERLIN Plus System Features