Installation guide

You can modify this message to include the following statement:
“You have reached nnn...”
where nnn... is the telephone number of one of your outside lines. The number
can be up to 16 digits, including * or #. You can modify the message for all lines
in an incoming line group, or you can modify the message for some and leave
others unmodified. To modify the DXD message for one or more lines in your
incoming line groups, do the following:
1 Enter administration mode by sliding the T/P switch to P and touching
Administer.
2 Dial *50.
3 Touch the line button for the line on which you want the modified message.
The green light goes on.
4
Dial the telephone number you want to include in the message.
NOTE:
For special phone numbers, such as an 800 number, you may prefer
to have the recorded voice say “Eight hundred” followed by the
number, instead of “Eight, zero, zero.” In this case, you would touch
Hold to enter a pause after the toll prefix, then again after the 800
area code, and again after the exchange. For example,
1-800-555-1212 would be entered as follows:
1
Hold 800 Hold 555 Hold 1212
5 Repeat for other lines.
6 Touch Administer.
The console beeps twice.
7
Leave administration mode by sliding the T/P switch to the center position.
T P
Administer
555-1234
■ ■ ■
■ ■ ■
■ ■ ■
■ ■ ■
tel. no.
50
T P
Administer
MERLIN Plus System Features
5-61