User`s guide

How to Program
How to Use
1 Label a button with lights.
To prevent calls from ringing at your phone:
2 Enter programming mode by sliding the T/P
1 Press Do Not Disturb.
switch to P. (Digital phones: Dial #33.)
The green light next to the button goes on.
3 Press the button you want to program.
This feature remains active until you:
4 Dial *71.
5 Program another feature, or leave
programming mode by sliding the T/P switch
to the center position. (Digital phones: Dial
#00.)
1 Press Do Not Disturb again.
The green light next to the button goes off.
Drop
CONSIDERATIONS
DESCRIPTION
If you get a busy signal or no answer as you set up a conference call, or if
you want to disconnect a person or line you added to the conference call, you
can use the Drop feature.
● Only the originator of the conference call can drop people from the
conference.
● If you press the switchhook, you cut off everyone on the call.
● If you drop a line that has other people bridged onto it, those people are
also disconnected from the conference call.
RELATED FEATURES
● Conference
How to Program
No programming necessary.
How to Use
To disconnect a person or line in a conference
call:
1 Press Drop.
2 Press the line button of the person you want to
disconnect from the conference.
3-54 MERLIN II System Features