User`s guide

How to Program
How to Use
To place a ringing intercom call with one touch:
1 Label a button (one with lights is preferred but
not required).
1 Press the Auto Intercom button for the
2 Enter programming mode by sliding the T/P
intercom number you want to reach.
Your speaker goes on and you hear ringing.
switch to P. (Digital phones: Dial #33.)
3 Press the button you want to program.
2 If the other person answers, lift your handset.
If not, press Speaker or Speakerphone to
4 Dial *91 plus an intercom number.
cancel the call.
5 Program another feature or leave programming
mode by sliding the T/P switch to the center
To place announced intercom calls:
position. (Digital phones: Dial #00.)
1 If the red light next to it is not already on,
press Intercom-Voice.
2 Press the Auto Intercom button for the
intercom number you want to dial.
Your speaker goes on and you hear a beep.
3 Lift your handset and begin speaking.
Automatic Line Selection
DESCRIPTION
You can program the order in which your system makes lines available to you
for outside calls. For example, if you usually make long distance calls, you
might specify a WATS line as the first line in your Automatic Line Selection.
Whenever you lift your handset or press Speakerphone, the system connects
you to the WATS line, unless you select another line manually. If the first
line in your Automatic Line Selection sequence is busy, the system connects
you to your second choice line, and so forth.
CONSIDERATIONS
● You can place up to eight lines in an Automatic Line Selection sequence.
● You can include either outside lines, tie lines, or intercom lines in the
sequence, but you should not mix the three types of lines.
● If your system is administered for Dial Access for Line Pools or for
Automatic Route Selection, you probably won’t need Automatic Line
Selection, unless you have a private line.
● If you plan to program other features when you program Automatic Line
Selection, you must program Automatic Line Selection first. If you’re
already in the middle of a programming session, leave and reenter
programming mode before you program Automatic Line Selection.
MERLIN II System Features 3-15