User`s guide

Forced Idle Signals
To perform most administration procedures, the system must be idle, that is,
have no calls in progress.
If you get the message “System Busy,” you must
wait until the system is idle, then try the procedure again later.
Printouts
If you have a printer, you can get printouts that show how certain features
have been administered. You order printouts by entering a code or pressing
a button at the Display Console while you’re in administration mode.
Instructions for getting printouts are included in the “How to Administer”
section of the appropriate feature.
IMPORTANT:
Be sure to wait until printing is done before leaving
administration mode. You will hear two beeps at the console
when printing is completed.
Don’t remove the printout until
you’ve left administration mode, or your page alignments will
be affected.
Overview 3-5