User`s guide

How to Program
How to Use
No programming necessary. To make a call on a dial repeating tie line:
1 Lift your handset.
2 Press the line or line pool button for the tie line
you want to use.
3 Dial the extension you want.
To make a call on an automatic ringdown tie line:
4 Lift your handset.
5 Press the line or line pool button for the tie line
you want to use.
Your call rings at an attendant station of the other system.
6 Ask the attendant to connect you to the person
you are calling.
Touch-Tone or Rotary Signaling
DESCRIPTION
The MERLIN II system is factory-set to send or generate Touch-Tone signals. If
some of the system’s lines generate rotary pulses, you need to identify each of
those lines to the system.
If you are not sure whether lines are Touch-Tone or rotary, perform this test at
the display console:
● Press each line button and dial an outside number.
If the line is Touch-Tone, you hear tones and the dial tone stops. If the line is rotary, you hear
tones, but the dial tone is not interrupted.
How to Administer
1 Enter administration mode by sliding the T/P switch to P.
2 Press Conference twice.
The administration menu appears.
3 Press [Lines], [More], [TchTone].
4 Press each line button until the light next to it shows the appropriate code:
Steady green on = Touch-Tone
Green off = rotary
5 Press Conference to return to the main administration menu, or leave administration mode by
sliding the T/P switch to the center position.
3-136 MERLIN II System Features