User`s guide

How to Administer (Continued)
To select the Tie Line Type option:
1
2
3
4
Enter administration mode by sliding the T/P switch to P.
Press Conference twice.
The administration menu appears.
Press [More], [More], [More], [TieLines], [InType].
➤ Enter the line number, then press [Enter].
➤ Select the tie line type option:
— Wink = wink start (default)
— Delay = delay dial
— Imm = immediate start
— Auto = automatic (for automatic ringdown)
NOTE: If the tie line is Touch-Tone signaling, the immediate start (Imm) option is
disallowed.
➤ Repeat step 3 for each tie line port.
➤ Perform the step 3 procedure again except select [OutType] from the TieLines menu instead
of
[InType].
➤ Repeat this procedure for each tie line port.
Press Conference to return to the main administration menu, or leave administration mode by
sliding the T/P switch to the center position.
To select the Signal type:
1 Enter administration mode by sliding the T/P switch to P.
2 Press Conference twice.
The administration menu appears.
Press [More], [More], [More], [TieLines], [E&MSignl].
➤ Enter the line number, then press [Enter].
➤ Select one of the following:
— Type1S = Type 1 Standard (default)
— Type1C = Type 1 Compatible
— Type5 = Type 5
3 Press Conference to return to the main administration menu, or leave administration mode by
sliding the T/P switch to the center position.
(Continued)
3-132 MERLIN II System Features