User`s guide

How to Program
How to Use
No programming necessary.
1 Press Loudspeaker Page.
2 Lift your handset.
3 Make your announcement.
4 Hang up.
The loudspeaker turns off automatically.
Manual Signaling
DESCRIPTION You can use a Manual Signaling button to generate a beep at a co-worker’s
CONSIDERATIONS
phone. Program a Manual Signaling button for each person you want to
signal.
● You can signal someone with a Manual Signaling button while you have
an outside call in progress.
● The beep sounds at your co-worker’s phone even if it is busy.
● If you program this feature on a button with lights, the green light next to
the button goes on when your co-worker uses his or her phone or uses
the Do Not Disturb feature.
● You cannot have both a Manual Signaling button and an Auto Intercom
button for the same person. If you try to program both, you deactivate the
feature that you programmed earlier.
How to Program
How to Use
1 Label a button.
To signal a co-worker:
2 Enter programming mode by sliding the T/P
1 Without lifting your handset, press the Manual
Signaling button.
switch to P. (Digital phones: Dial #33.)
3 Press the button you want to program.
To place an intercom call using a Manual
4 Dial *60 plus the intercom number of the
Signaling button:
person you are signaling.
1 Press Intercom-Voice or Intercom-Ring.
5 Leave programming
mode by sliding the T/P
2 Lift the handset.
switch to the center position. (Digital phones:
Dial #00.)
3 Press the Manual Signaling button.
MERLIN II System Features
3-91