User`s guide

How to Administer
1
2
3
4
5
6
7
8
9
Have your completed Forms 3a through 3g, Station Configuration Form handy.
Enter administration mode by sliding the T/P switch to P.
Press Conference twice.
The administration menu appears.
Press [Stations], [Line/Pool].
Press the Auto Intercom button for the phone.
Press
[Enter].
NOTE: If the phone is being used, the message,
your display. You must either wait until
again later.
“Station Busy - Please Wait,” shows on
the station becomes available or try
Press the line buttons until the correct code shows:
Green light on = line is assigned to the phone
Green light off = line is not assigned to the phone
If you want to give another phone the same line assignments
up, use the following shortcut:
as one you have already set
NOTE: Be aware that when you copy line assignments, you also copy
call restrictions and allowed-list permissions. Be
-
sure you want the two phones
to be identical in these respects before using this copy procedure.
a
b
c
d
e
f
g
To
7.
Press
[Copy].
In response to
copying from.
In response to
the prompt, press the Auto Intercom button of the station you are
the prompt, press the Auto Intercom button of the station you are
copying to.
Press
[Enter].
You hear a 2-beep signal to let you know that the copy procedure is complete.
Repeat steps b through e for each phone for which you want to copy line assignments.
Press
[Exit] to return to the Stations screen.
make line assignments to a different phone, press
[Line/Pool] and repeat steps 5 through
Press Conference to return to the main administration menu, or leave administration
mode by sliding the T/P switch to the center position.
How to Program
How to Use
No programming necessary. The MERLIN II System User’s Guides explain
how to place calls in square systems. Be sure that
everyone in your business knows how to use the
line buttons in square systems.
3-88 MERLIN II System Features