User`s guide
How to Administer (Continued)
d In response to the prompt, press the Auto Intercom button of the station you are
copying to.
e Press
[Enter].
You hear a 2-beep signal to let you know that the copy procedure is complete.
f Repeat steps b through e for each phone to which you want to copy line assignments.
g Press
[Exit] to return to the Stations screen.
8 Press
[Line/Pool] and repeat steps 2 through 7 to assign additional lines or pools to buttons.
9 Label the line buttons that you have assigned to each phone.
10 Press Conference to continue administration or leave administration mode by sliding the
T/P switch to the center position.
To assign dial access to line pools to phones
1
2
3
4
5
6
To assign Dial Access to Line Pools to phones, press
[Stations], [DialAcc].
Press the Auto Intercom button for the phone.
Press
[Enter].
NOTE:
If the phone is being used, the message,
your display. You must either wait until
again later.
“station busy - please wait,” shows on
the station becomes available or try
Press the line buttons until the correct code shows:
Steady green on
= phone has Dial Access to the pool containing the line
Green off
=
phone doesn‘t have Dial Access to the pool containing the line
If you want to duplicate the Dial Access to Line Pool assignments on another phone, use
the following shortcut:
NOTE:
Be aware that when you copy line assignments, you also copy call restrictions
and allowed-list permissions.
a Press
[Copy].
b In response to the prompt, press the Auto Intercom button of the station you are
copying from.
c Press
[Enter].
d In response to the prompt, press the Auto Intercom button of the station you are
copying to.
e Press
[Enter].
You hear a 2-beep signal to let you know that the copy procedure is complete.
f Repeat steps b through e for each phone to which you want to copy line assignments.
g Press
[Exit] to return to the Stations screen.
Press
[DialAcc] and repeat steps 2 through 4 to assign Dial Access to additional phones.
Press Conference to continue administration or leave administration mode by sliding the
T/P switch to the center position.
3-84 MERLIN II System Features