Specifications
4 Touch Administer.
The console beeps
twice.
6
Continue to administer the system, or leave administration mode.
PAGING GROUPS
When you filled in the “Paging Groups” columns on the System
Configuration Form, you learned the following about paging groups:
l
All voice terminals are automatically assigned to a single paging group,
the Page-All Group, which you cannot change.
l
Intercoms 10 through 19 are automatically assigned to Page Group 1;
intercoms 20 through 29 are automatically assigned to Page Group 2.
l
You can assign the same voice terminal to both paging groups.
l
If you are using a BIS-10 or
a
BIS-22 voice terminal, you must administer
the Group Page feature in a slightly different way.
Look at the “Paging Groups” columns on the System Configuration Form. If
you plan to keep intercoms 10 through 19 in Page Group 1 and the remaining
intercoms in Page Group 2,
yolou
don’t have to
do
anything here.
If you plan to
change the makeup of the paging groups, follow the procedure below:
1
Enter administration mode.
The red lights go
on
next
to
Administer
and
Restrict.
2
Dial
*71
for Page Group 1 or
*72
for Page Group 2.
If
you have the corresponding Auto Intercom buttons, a green light goes on next to each
one that already is assigned to that paging group.
3
Perform one of the following procedures:
D
Touch the appropriate Auto Intercom button(s).
The green light goes on.
ti
Dial a code from the Dial Code chart (located earlier in this section
under “Using the BIS-22 Voice Terminal as an Administrator Console”)
that corresponds with the voice terminal.
4 Touch Administer.
The console beeps twice.
5
Follow steps 2 through 4 for each paging group you want to administer.
6
Continue to administer the system, or leave administration mode.
VOICE TERMINAL
TEMPLATES
If you have entered a number 1 through 4 under the “Template” column of
.
your “Voice Terminal” form, use the following procedure to assign the
template to the voice terminal:
1
Enter administration mode.
The red lights go on next to
Administer
and
Restrict.
2
Dial
*lO
followed by the option number of the template:
1
=
Clear Template
2
=
Dialer Template
3
=
Feature Template
4
=
ReceptionistlSecreta
y Template
3-16 Basic Administration