Specifications

Leaving Administration Mode
Follow the boxed instructions below when you’ve finished an administration
session.
Leaving Administration Mode
To leave administration mode:
1 Slide the TIP switch on the left side of the console to the center
position.
The red light goes ofi next to Administer and Restrict.
The red light goes on next to a line button.
CONFIRMATION AND
ERROR SIGNALS
Many of the administration and programming procedures described in this
manual require you to enter a star code (that is, dial * plus one or more
digits). Many procedures also require you to enter intercom numbers or other
sequences of digits.
Confirmation Signal
If you enter a star code that the system recognizes, the console beeps twice
when you touch Administer to conclude the procedure. The two beeps
confirm allowable input.
Error Signal
You will hear only one beep from the attendant console if you make one of
the following errors:
l You enter an unrecognized star code.
0 You enter a nonexistent intercom number.
l You enter one or more digits that are inconsistent with the administration
procedure.
l You attempt to administer a voice terminal that is active on a call or in
program mode.
l You attempt to assign an alternate attendant position with the System
Answer feature on.
To recover from the error, touch Administer and begin the procedure again.
Administration Preview 3-9