Specifications

None
HOW TO USE
To program a Touch-Tone Enable button for your voice terminal:
1 Label the button Touch-Tone Enable.
2 Slide the TIP switch to P.
The voice terminal rings every 5 seconds to remind you that you are programming and that
you cannot place or receive calls.
3 Touch the button you want to program.
4 Dial *76.
s Slide the T/P switch to the center position.
To switch from rotary pulse to Touch-Tone signals as you dial a number:
Touch Speakerphone or lift your handset.
Dial the first part of the number.
Touch Touch-Tone Enable.
Dial the remaining numbers.
Touch-Tone or RcHaq Setting
CONSIDERATIONS
ADMINISTRATION
When the MERLIN Plus system is installed, it is set to generate Touch-Tone
signals. If any of the system’s lines are rotary, the administrator must reset
the system to rotary dialing by entering a code at the administrator/attendant
console.
If your system has any rotary lines, you should select the rotary setting for
the system then program a Touch-Tone Enable button which can be activated
when you are using your Touch-Tone lines. (See “Touch-Tone Enable” .)
If your responsibilities do not include system administration, skip this
information.
To set your system for rotary dialing:
1 Enter administration mode by sliding the TIP switch to P and touching
Administer.
MERLIN Plus System Features s-121