Specifications

Test
DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
HOW TO USE
2 Touch the System Speed Dial button for the particular code.
3 If the special character STOP is included in a system speed dial number,
after you hear the second dial tone, dial the System Speed Dial code again
to continue the dialing.
When you need to test the lights and the ringing on your voice terminal, or if
you need to verify that your voice terminal has been installed correctly, you
can use the Test/Program (TIP) switch on the left side of your voice terminal.
If your system administrator has administered the Program Mode Lock
feature for your voice terminal, you cannot use the T/P switch for changing
programmed features at the voice terminal. However, you can still use the
TIP switch for testing voice terminal lights and ringing.
None
None
To test the lights and ringing on your voice terminal:
1 Slide the TIP switch to T. On some voice terminal models you must hold
the switch in that position until you are finished testing’ your voice
terminal.
The red and green lights next to your voice terminal buttons flash alternately, and your
voice terminal rings.
2 Slide the TIP switch to the center position.
If your voice terminal does not respond when you slide the Test/Program
switch to T, check Section 7, “Troubleshooting the System,” for possible
causes and recommended action.
MERLIN Plus System Features
5-117