Specifications

HOW TO USE
None
System Reset
DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
WARNING: This feature is intended for service personnel only.
When the service prson or the administrator uses System Reset, the entire
MERLIN Plus system is set to the initial feature assignments, and
consequently erases any system administration, such as System Speed Dial
numbers or call restrictions. It is useful when making radical changes to the
system or starting administration over again.
When the the service person on the administrator resets the system, all
programming done for any voice terminal in the MERLIN Plus system is
erased. If the administrator has administered customized line assignments for
any voice terminal, these are erased also, and the line configuration is
returned to square operation. All administered features are erased.
System Reset requires readministering your system and reprogramming all
voice terminals.
To reset your system to the initial feature assignments:
Enter administrativn mode by sliding the TIP switch to P and touching
Administer.
Dial *99198.
The console beeps twice.
s
NOTE: If the console beeps only once or not at all, the reset didn’t work,
probably because som&one was using the system when you dialed the
System Reset code. Wait until no one is using the system, and try the
reset again.
Go to the control unit and turn off the power for ten seconds, then turn it
back on.
The red lights go on, and the green lights flash.
The console rings every 5 seconds.
Touch Administer.
The console beeps twice.
Leave administration mode by sliding the TIP switch to the center
position.
MERLIN Plus System Features 5-113