Specifications

5 Touch Administer.
The console beeps twice.
6 Leave administration mode by sliding the TIP switch to the center
position.
Control Unit Jack Assignment for the System Feature Report. To assign a
voice terminal jack on the control unit for the System Feature Report:
NOTE: The system is factory-set to have the data collector and printer
connected to voice terminal jack 19 for the System Feature Report
feature.
1 Enter administration mode by sliding the TIP switch to P and touching
Administer.
2 Dial *85.
3 Touch the Auto Intercom button or dial the intercom number of the jack
to which the data collector and the printer will be connected for the Call
Report feature.
The green light next to the current jack assignment goes off; the green light next to the
Auto intercom button for the jack to which the data collector and the printer zvill be
connected goes on. .
4 Touch Administer.
The console beeps twice.
5 Leave administration mode by sliding the TIP switch to the center
position.
Complete Sfstem Report. To print out a system administration report and a
report for every voice terminal in your system:
1 Enter administration mode by sliding the TIP switch to P and touching
Administer.
2 Dial *60.
The printer prints the reports as it receives the data from the system.
3 Touch Administer.
The console beeps twice.
4 Leave administration mode by sliding the TIP switch to the center
position.
System Administration Report. To print out a system administration report
only:
1 Enter administration mode by sliding the TIP switch to P and touching
Administer.
..--. ._. -. ^ - - ._.