Specifications

Gaining Access to a Line using RLA
If the system is in RLA mode, you can gain access to a line in the RLA
outgoing line group from a remote location by following this procedure:
NOTE: If you will be using this feature, ask your system administrator
for the handy MERLIN Plus CFlRLA Card that provides instructions
for RLA.
1 Dial the telephone number of a line in the RLA incoming line group.
2 When the call is answered, the VSP begins prompting you through the
procedure in which the following information is called for:
NOTE: The system verifies each response, such as the correct password or
unrestricted lines or telephone numbers. If the response is incorrect or
not allowed, the system requests the caller to respond again.
l Enter the 5-digit password (the first two digits are a valid intercom
number).
l Enter the telephone number you want to reach plus a # .
3 When you have finished responding to the voice prompts, you will hear
normal call-progress tones (ringing, busy signal, fast busy signal, etc.).
4 Complete your call as usual.
pgEJ-q
If the system is in either CF or DXD mode, you can gain access to a line in
the RLA outgoing line group from a remote location by following this
procedure.
1 Depending on the mode the system is in, dial the telephone number for a
line in either the CF or the DXD incoming line group.
When the call is answered, the VSP gives the appropriate message.
2 As soon as the message ends, dial * # *.
The VSP begins prompting you through the RLA procedure.
3 Respond appropriately to the voice prompts until you hear normal call-
progress tones (ringing, busy signal, fast busy signal, etc.).
4 Complete your call as usual.
gii.li.I/
MERLIN Plus System Features 5-95