Specifications

ADMINISTRATION
If your responsibilities do not include system administration, skip this
information.
1 Enter administration mode by sliding the T/I’ switch to P and touching
Administer.
2 Dial *57.
The green light goes on next to those lines that cannot be bridged or monitored.
3 If you want to change the Privacy setting of either Line A or Line E, touch
the line button until the green light next to it shows the setting you want:
Green light on = the line is private
Green light ofj = the line can be monitored
4 Touch Administer.
The console beeps twice.
5 Leave administration mode by sliding the TIP switch to the center
position.
i,
si
Ii
I[
n n n
. . .
n mm
n n n
*57
T .P
PROGRAMMING
None
HOW TO USE
None
DESCRIPTION
By using the Test/Program switch and following the instructions listed below,
you can program features that you have selected for your voice terminal onto
available buttons.
CONSIDERATIONS
There are several programmable features that you can use with either a
button or a dial code. Therefore, if you have a limited number of available
feature buttons on your BIS-10 or BIS-22 voice terminal, you may choose to
use a dial code rather than program any of those features onto your voice
terminal.
If you make a mistake when programming a button, simply touch the button
again and redial the programming code and all required numbers.
The system administrator can use the Program Mode Lock feature to prevent
people within the system from changing programming assignments on their
voice terminals. (See “Program Mode Lock. “)
MERLIN Plus System Features
5-87