Specifications

3 Leave administration mode by sliding the TIP switch to the center
position.
Number of Rings
To change the number of rings (the default is two rings) before the DXD call
is answered:
1 Slide the TIP switch to P and touch Administer.
2 Dial *761 plus the number of rings (between 0 and 9) before call is picked
UP*
NOTE: If the number of rings is set to 0, the voice terminal will not ring,
and the calls will be answered immediately.
3 Touch Administer.
The console beeps twice.
4 Leave administration mode by sliding the T/P switch to the center
position.
You can modify this message to include the following statement:
“You have reached mm.. ’
where nnn.. .
is the telephone number of one of your outside lines. The
number can be up to 16 digits, including * or # . You can modify the
message for all lines in an incoming line group, or you can modify the
message for some and leave others unmodified. To modify the DXD message
for one or more lines in your incoming line groups, do the following:
1 Enter administration mode by sliding the TIP switch to P and touching
Administer.
2 Dial *50.
3 Touch the line button for the line on which you want the modified
message.
The green light goes on.
4 Dial the telephone number you want to include in the message.
NOTE: For special phone numbers, such as an 800 number, you may
prefer to have the recorded voice say “Eight hundred” followed
by the number, instead of “Eight, zero, zero.” In this case, you
would touch Hold to enter a pause after the toll prefix, then
again after the 800 area code, and again after the exchange. For
example, l-800-555-1212 would be entered as follows:
1 Hold 800 Hold 555 Hold 1212
MERLIN Plus System Features 5-47