Specifications

To set the current time:
1 Enter administration mode by sliding the TIP switch to P and touching
Administer.
2 Dial *81.
3 Dial two digits for the hour (00 through 23).
4 Dial two digits for the minute (00 through 59).
For example, if the time is 2:16 A.M., dial *810216; if the time is 2:16
P.M., dial *81 14 16.
5 Touch Administer.
The console beeps twice.
6 Leave administration mode by sliding the TIP switch to the center
position.
mpJ
Control Unit Jack Assignment for the Call Report Feature.
To specify the voice terminal jack to which the data collector and the printer
will be connected:
NOTE:
The system is factory-set for jack 19.
1 Enter administration mode by sliding the TIP switch to P and touching
Administer.
2 Dial *82.
The green light goes on next to the Auto Intercom button that corresponds with the jack to
which the data collector and the printer ar-e currently assigned.
3 Touch the Auto Intercom button or dial the intercom number of the jack
to which the data collector and printer are currently assigned.
The green light goes off next to the Auto intercom button that corresponds with the jack to
which the data collector and printer are currently assigned.
Touch the Auto Intercom button or dial the intercom number of the jack
to which the data collector and the printer will be connected.
The green light next to the button goes on.
4 Touch Administer.
The console beeps twice.
5 Leave administration mode by sliding the TIP switch to the center
position.