Specifications

HOW TO USE
Using the CF/DXD Button
A button with a red light next to it is required for the CF feature.
To program a CFlDXD button on a voice terminal:
1 Label the button CFIDXD.
2 Slide the TIP switch to P.
The voice terminal rings every 5 seconds to remind you that you’re programming and that
you can‘t place or receive calls.
3 Touch the button you want to program.
4 Dial *83.
5 Slide the TIP switch to the center position.
Touching the CFlDXD button repeatedly cycles the system through DXD, CF,
and normal modes. The red and green lights next to the CFlDXD button will
help you recognize which mode the system is in.
Green and red light off = Normal mode
Only green light on = DXD mode
Only red light on = CF mode
Red light flashing = Problem with CF
If the red light next to the CFlDXD button is flashing, notify the system
administrator who should refer to Section 7, “Troubleshooting. ’
To return to CF mode after an error has been corrected:
1 Touch CFlDXD three times.
The first time puts the system in normal mode; the second touch of the button puts the
system in DXD mode; the third touch puts the system in CF mode.
DESCRIPTION
If you want to pick up an intercom or outside call that is ringing at another
voice terminal, use the Call Pickup feature.
You can use this feature in three different ways:
l Option A-You can use a dial code and dial the intercom number of the
ringing voice terminal.
l Option B-You can program a Call Pickup button and dial the intercom
number of the ringing voice terminal.