Specifications

2 Enter administration mode by sliding the TIP switch to P and touching
Administer.
3 Dial *53.
4 Perform the appropriate step below:
w To enter or change a CF destination telephone number, dial the new
number.
b To remove the current CF destination number without replacing it
with another number, touch Administer.
5 Touch Administer.
The console beeps twice.
6 Leave administration mode by sliding the TIP switch to the center
position.
From Outside the System To enter or change the CF destination number
from outside the system while the system is in CF, DXD, or RLA mode,
follow this procedure.
NOTE: This procedure is available on the MERLIN Plus CFlRLA card, so
that ;ou can refer to it when you’re changing the CF destination
while off-site.
Dial the telephone number for one of the lines in the CF incoming line
group.
When the call is answered, you hear the CF voice message.
During the voice message, dial * # *.
The system goes into RLA mode, and the VSP asks you to enter your password.
NOTE: If a voice prompt is not administered, the CF destination number
cannot be changed from outside the system.
At the voice prompt, enter your password.
The VSP asks you to enter a line number.
At the voice prompt, dial 00.
The VSP asks you to enter the new call fonoard number followed by a pound (#).
Dial the new CF telephone number plus a pound ( #).
The VSP repeats the new number and asks you to either confirm it by dialing a * or deny it
by dialing 00.
Dial * to confirm, or dial 00 to return to step 5, above, and try again.
After receiving the confirmation signal, the VSP repeats the new number once more and
identifies it as the new call forward number.
Hang up.