Specifications

CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
HOW TO USE
Speakerphone or lift your handset, the system automatically selects the line
you usually use.
If that line is busy, the system then selects your second
choice, such as a WATS or Readyline, unless that line is busy too, and ‘so on.
You can include all or only some of your outside lines in an Automatic Line
Selection sequence.
If you plan to program other features when you program Automatic Line
Selection, you must program Automatic Line Selection first. If you are
already in the middle of a programming session, slide the TIP switch to the
center position and then back to P before programming this feature.
The Automatic Line Selection order is only for outside lines; the line selection
does not include intercom lines. However, if you remove all outside lines
from your Automatic Line Selection sequence, your system will select an
intercom line when you touch Speakerphone or lift the handset. (See
‘Intercom Preference. “)
If you don’t program an Automatic Line Selection sequence, you will get
outside lines according to the sequence in which they are plugged into the
control unit.
None
To program an Automatic Line Selection sequence for your voice terminal:
1
Slide the TIP switch to P.
The voice terminal rings every 5 seconds to remind you that you are programming and that
you cannot place or receive calls.
2 Dial **.
3
Touch the line buttons in the order you prefer.
4
If you want to continue programming other features, dial ** again.
Otherwise slide the TIP switch to the center position.
IT
. P
When you want to place an outside call:
1
Touch Speakerphone or lift your handset.
The MERLIN Plus system connects you to the first available line in the Automatic Line
Selection sequence.
MFRI IN Plrrs Sv.ct:tF?m Featlwnsa
S-15