Instruction manual

Installing the Carriers
2-35
Installing the Control Unit
CAUTION:
To avoid damage, do not force the module. If the module does not
insert easily, pry the bottom-front locking tab with a flat-blade
screwdriver, remove the module, and inspect the module and carrier
for damage or obstruction. The bottom-front locking tab is shown in
Figure 2-11. This tab is used on all modules.
If there is no damage and no obstruction, reinsert the module.
A damaged carrier or module must be replaced.
3. Firmly push the processor into the carrier until it locks into place.
The processor should be securely attached to the carrier and locked in
place by the locking tab on the bottom front of the processor.