Instruction manual

System Programming
8-64
Installation, SPM, Maintenance, and Troubleshooting Supplement
System Programming 8
A primary function of WinSPM is to provide a method for programming the
system. The Sys Program option gives you access to all of the system
programming features available from the system programming console.
Basic Programming Information 8
To begin programming, you must perform one of the following to display the
System Programming menu on the MLX-20L or 4424LD+ console, or on the
PC:
In most cases, you can click
 (Back) to exit from a screen without making
any changes. Exceptions to this are noted as part of a procedure. When you
complete a procedure and click
 (Back), you usually move up one screen in
the menu hierarchy. Occasionally, when you click
 (Back), you return to the
previous screen. In a few cases, clicking
 (Back) brings you back to the
System Programming menu, where you can select another option to program
or exit from system programming.
To complete a procedure and save the information you have programmed, click
 (Enter).
If you are programming a group of sequentially numbered extensions or trunks,
you may have the option of clicking
 (Next). This saves your entry and
automatically provides the number of the next extension or trunk in the
sequence, thus saving you a couple of steps. If Next displays on the screen,
you can use it with the current option.
In most cases, you will be at an intermediate step in the procedure you have
just completed. At that point, you can select one of the options shown on the
screen and continue programming, or you can click
 (Back) again. This
usually takes you back to the System Programming menu. If not, you again can
continue programming on the current screen or click
 (Back) again.
On the console: Menu
→Sys Program →Back
On the PC: Type spm
→1→Press any key→→