Instruction manual

Basic System Management Procedures
8-62
Installation, SPM, Maintenance, and Troubleshooting Supplement
— If any real board is out of sequence with the boards listed on the
backup disk.
— If phantom boards are not listed last.
— If the operating mode of the system being restored is Hybrid/PBX, but
the control unit processor module has been modified to operate only in
Key mode.
■ A successful restore is followed automatically by a Restart (cold start).
WARNING:
An unsuccessful or terminated restore results in a System Erase
(frigid start). All calls are dropped. The system configuration is
erased. All system programming is lost and the system returns to the
factory settings. If the restore is being done remotely, the connection
is dropped immediately. If this happens, attempt to reconnect to the
control unit and immediately perform another restore. If this is not
successful, programming must be restored on site.
Standard SPM
→Select Restore→Select hard disk or
floppy
→→Select a file→1→<
to abort
→1
WinSPM
1. From the WinSPM Main window Outlook bar, select Tools.
2. From the Outlook bar, click the Restore icon.
A selection dialog box displays.
3. Select the File option.
4. Click OK.