Instruction manual

Basic System Management Procedures
8-42
Installation, SPM, Maintenance, and Troubleshooting Supplement
Table 6-2 gives a brief description of each procedure.
Table 8-2. Management Procedures
Option Function
Sys Program To program the system.
Backup
1
1 WinSPM option only. Not available on the system programming console. To be used only
by qualified service personnel.
To make a backup copy of your system programming and
store it on a floppy disk or on hard disk.
Boards
1
To show which modules (port boards) are in each slot of
the control unit and allows you to assign boards to slots.
Print Opts
1
To direct reports to printer or to the PC for storage on a
floppy disk or on hard disk.
Monitor Restricted to use by your technical support organization.
Maintenance Restricted to use by your technical support organization
and qualified technicians.
Restore
1
To restore your system programming from floppy disk or
from hard disk.
Pass-Thru (IS II/III and 100R INA only) To make a remote
connection, through the control unit, to a 100R INA
module or IS II/III PC to program applications on the IS II/
III PC.
Password To change the password for remote entry into the system
Language To select a language (U.S. English, Canadian French, or
Latin American Spanish) for the console simulation
window on the PC. (There is also a Language option
available on the System Programming menu that allows
you to set the System Language.)