Instruction manual

Getting Started
8-17
System Programming Maintenance
Example: You are connecting to a remote MERLIN MAGIX Integrated
System via a modem through the Remote Access line 800 555-9999. The
Remote Access line is set up with barrier code 1234 for access to the
remote dial tone. The site from which you are dialing requires you to dial 9
to get an outside line. Using commas for pauses in the dial string, the dial
string would be 918005559999,,,,,1234,*10.
8. If you want to add another site, click Add and begin on Step 2 in the
process for the appropriate connection type for the next site.
9. When you finish adding sites, click Apply.
Manual Connection 8
To set up a site for a Manual Connection, do the following:
1. Using the instructions packaged with your PC modem, verify that the
software and hardware flow control is disabled in the modem properties.
This is required when connecting to a MERLIN MAGIX Release 1.5 or later
system, and is recommended for all releases of the communications
system.
2. From the Site Setup screen, click Add. The cursor moves to the Site Name
field.
3. Type in the Site Name you wish to use and press the Tab key. Site Names
are limited to 30 characters. You may use only characters that are
acceptable for filenames in the Windows environment.
■ If you have multiple modems installed in your system, after clicking
OK, you may be prompted to select the modem you want to connect
with.
■ Clicking CANCEL from the Connection Selection screen causes you
to return to either the Main screen or the First-Time User Wizard,
depending on from where the screen was started.