Instruction manual

Getting Started
8-14
Installation, SPM, Maintenance, and Troubleshooting Supplement
8. If you want to add another site, click Add and begin on Step 2 in the
process for the appropriate connection type for the next site.
9. When you finish adding sites, click Apply.
Internal Connection 8
To set up a site for an Internal Connection, do the following:
1. Using the instructions packaged with your PC modem, verify that the
software and hardware flow control is disabled in the modem properties.
This is required when connecting to a MERLIN MAGIX Release 1.5 or later
system, and is recommended for all releases of the communications
system.
2. From the Site Setup screen, click Add. The cursor moves to the Site Name
field.
3. Type in the Site Name you wish to use and press the Tab key. Site Names
are limited to 30 characters. You may only use characters that are
acceptable for file names in the Windows environment.
■ If you get a message indicating that the cable between your PC and
the communications system is not connected, check to be sure that
the cable is connected properly. If the cable is connected properly,
try disabling Direct Connection Detection in the Options screen.
■ If you have multiple modems installed in your system, after clicking
OK, you may be prompted to select the modem you want to connect
with.
■ Clicking CANCEL from the Connection Selection screen causes you
to return to either the Main screen or the First-Time User Wizard,
depending on from where the screen was started.