Instruction manual

Upgrading from a MERLIN LEGEND System
7-12
Installation, SPM, Maintenance, and Troubleshooting Supplement
5. As necessary, add a Bridge module you need to fill up the single empty slot
at the end of the last plastic carrier before the metal carrier. To add a Bridge
module, select “Bridge” from the Boards screen in System Programming.
(Bridge module programming is available in Release 1.5 or later of the
MERLIN MAGIX system.)
6. If you are adding a 100R INA module, place it in the first slot of the metal
carrier.
7. Add any other modules you want to the metal carrier.
8. Power up the system.
9. Perform a board renumber.
10. If you have added a MERLIN Messaging System Release 2.0 module to
the metal carrier, you must program for it in one of the two following ways:
■ If you have chosen to use the existing Voice Mail Calling Group, add
the extension numbers assigned to the MERLIN Messaging ports to
this calling group. Also, add the line numbers that go to this calling
group. As needed, enable rotary dialing.
■ Run the automatic configuration for Release 2.0 of the MERLIN
Messaging System. (See the MERLIN MAGIX™ Integrated System
Release 1.5 Release Notes.) As necessary, program the restriction for
outcalling and program the lines that are to ring in the Voice Mail
Calling Group.
You can program a Bridge module only from a PC running
WinSPM.