Instruction manual

Upgrading from a MERLIN LEGEND System
7-5
Upgrading to MERLIN MAGIX Release 1.5
Installing and Removing the
Plastic Shell
7
You can add or remove a plastic shell to or from modules, depending on
whether you are going to use them in a plastic carrier (with shell) or a metal
carrier (without shell).
Installing the Plastic Shell 7
Follow these steps to enclose a module with a plastic shell so that the module
can be used in a plastic carrier (see Figure 7-1):
1. Insert the two alignment tabs on the left housing through the two circuit
board slots behind the module faceplate.
2. Rotate the module into position so that it aligns correctly on the five pins in
the left housing.
3. Insert the two alignment tabs on the right housing behind the faceplate
(see Figure 7-2).
4. Rotate the right housing into position so that the five snaps lock into
position.
The 100R INA module cannot be encased in a plastic shell.