Instruction manual

System Testing and Verification
(3).
Dial the directory number for the BRI line assigned to the
station you are calling, If Centrex lines are connected dial a
“9" before the telephone number.
— Dial tone goes off after the first digit is dialed.
— After the last digit has been dialed, you hear ringback at the calling
station and ringing at the station being called.
If either is missing, verify that the dialed digits are correct for the BRI
line assigned to the button at the destination station, Redial if
necessary, If the test fails again, write “n” in the “Outgoing Call”
column of the planning form and write the type of tone, if any, that
you hear at the calling and destination stations in the “Comments”
column of the planning form.
(4).
Answer the call at the destination station,
(5).
Verify connectivity,
d. Using the procedure in 5
C above, place a test call from station D to station B.
When you answer the call on station B, check for station D’s calling party
information on the station B’s display. Record the results of the test on the
planning form. If the test fails, assign another line to station B and repeat the
procedure in step 5
C above.
e. Using the procedure in 5
C above, place a test call from station D to station C.
When you answer the call on station C, check for station D’s calling party
information on the station C’s display. Record the results of the test on the
planning form, If the test fails, assign another line to station C and repeat the
procedure in step 5
C above,
NOTE:
Calling Party Number/Billing Number (CPN/BN) information may not be sent or
displayed if All Call Privacy is activated.
6. Program the BRI Access button on station A:
a. Press Menu ➜ SysProgram ➜ Exit ➜ More ➜ Cntr-Prg ➜ Program Ext.
b. Enter the station’s extension.
C. Press Enter ➜ Start,
d. Select a blank button within the first ten buttons,
e. Press ListFeature ➜ BRIAccess ➜ Home.
f. Verify that the BRI Access button has been programmed using the Inspect
procedure in step 5b above,
g. Press Home,
7. Select the number of sequential pairs (part of the same DSL) of BRI lines
corresponding to the number of blank buttons on station A, Remember to skip the
lines assigned to stations B and C. Assign the BRI lines to buttons on station A using
the procedure in step 5a and verify button assignment using the procedure in
step 5b above.
18 Basic Rate Interface (BRI) Provisioning Guide