Instruction manual

System Testing and Verification
d. A module that fails a test should usually be removed. Remove the module from
the module as follows:
(1).
(2).
(3).
(4).
(5).
(6).
(7).
Put the module back in service:
Press Menu ➜ Maintenance ➜ Slot.
Enter the number of the module,
Press Enter ➜ Restore ➜ Yes,
Wait for the restore to complete.
Turn the system off,
Remove the module.
Shift the modules to remove any resulting empty slots
between modules.
Turn the system on,
Wait for the red LED on the processor module to go off,
Continue testing each module.
9.
10.
Plug BRI DSLs into the ports on the 800 CO-BRI modules, starting with the bottom
port on the first module, continuing sequentially toward the top port, Proceed
to the next module, and plug BRI DSLs into the ports in the same order. It is
recommended that you plug in the DSLs sequentially in order of their
respective DNs,
Program the SPID for each BRI line. Once the SPID is programmed, the BRI line is
activated. (Press
Exit at anytime to leave system programming without
saving the current changes.)
a.
b.
c.
d.
e.
Press Menu ➜ SysProgram ➜ Exit ➜ LinesTrunks ➜ More ➜ BRI ➜
ServProfid.
Enter the line number of the BRI line.
Press
Enter.
Enter the ten-digit SPID for the BRI line.
If more BRI lines require SPID programming, press
Next and repeat from step
13d above, When the SPID is programmed for all BRI lines, press
Enter ➜
Home.
Basic Rate Interface (BRI) Provisioning Guide 15