Instruction manual

MERLIN LEGEND Communications System Release 5.0
System Planning
555-650-112
Issue 1
June 1997
Lines/Trunks
Page 3-10Selecting Line/Trunk Options
3
Function Information 3
If the system has AUDIX Voice Power/Fax Attendant System, you can use the
Function column to indicate which service is available for those jacks. You can
also use this column to indicate whether a jack connects a personal line and,
therefore, has an owner.
Planning Form Instructions
In the Function column of Form 2c, do one of the following:
■ If a jack is used for a special purpose, note the purpose. For example, if the
system has AUDIX Voice Power/Fax Attendant System, indicate the
service by writing one of the following for the appropriate jack:
— For Automated Attendant, write AA.
— For Call Answer, write CA.
— For Information Service, write IS.
— For Message Drop, write MD.
— For Voice Mail, write VM.
— For Fax Response, write FR.
■ If a jack is used for a personal line, write the extension number of the
telephone.
Proceed to the next section, ‘‘
Selecting Line/Trunk Options’’.
Selecting Line/Trunk Options 3
You can select the following options for the incoming trunks connected to the
system:
■ Loop-Start Reliable Disconnect
■ Outmode Signaling
■ Toll-Call Prefix Dialing Requirements (Toll Type)
■ Hold Disconnect Interval
■ QCC Operator to Receive Calls (Hybrid/PBX mode only)
■ QCC Queue Priority (Hybrid/PBX mode only)
■ Pools
■ Remote Access
■ DS1 Connectivity
■ Tie Trunks
■ DID trunks