Instruction manual

MERLIN LEGEND Communications System Release 5.0
System Planning
555-650-112
Issue 1
June 1997
Control Unit Configuration
Page 2-26Numbering the System
2
Power-Integrated Solution II (IS II) or III (IS III), and Integrated Voice Power
Automated Attendant-IS II or IS III. Do not use the 008 OPT module for these
applications.
NOTE:
If the system has AUDIX Voice Power, the Integrated Administration
feature provides a single interface through Integrated Solution III (IS
III) for programming entries common to the system and to the AUDIX
Voice Power system. These common entries are noted on the
planning forms, and instructions for planning the system in
conjunction with planning for the AUDIX Voice Power system are
included in the procedures throughout this book. For more
information about this and other applications, see the
Feature
Reference
.
The system can accept up to eight application ports (extension jacks for
applications) using the 012 module [517G13(28)]. All 16 ports on the 016 module
(517A34) may be used for applications.
Table 2-6 shows, by application, the number of ports used, the number of TTRs
required, and the number of additional single-line telephones that can be added to
the modules. Use this table as a guideline.
Table 2-6. Application Ports
NOTES:
1. Older versions of the 012 module, (apparatus codes 517C13–517F13) if
one or more applications are used, only four tip/ring (T/R) devices may be
assigned to the module where the application is assigned, regardless of
how many jacks are open.
2. The applications discussed here do not work properly with 012 modules
manufactured for older MERLIN II systems. These applications must be
Application Ports TTRs Telephones
MERLIN MAIL 2
4
1
2
5 + 1 for the modem
3 + 1 for the modem
Lucent
Technologies
Attendant
1
2
3
4
1
1
2
2
6 + 1 for programming
5 + 1 for programming
4 + 1 for programming
3 + 1 for programming
AUDIX Voice
Power
2
4
6
8
1
2
3
4
6
4
2
0