Instruction manual

MERLIN LEGEND Communications System Release 5.0
System Planning
555-650-112
Issue 1
June 1997
Control Unit Configuration
Page 2-7Recording System Operating Conditions
2
Recording System Operating
Conditions 2
This section contains instructions for recording the following system operating
conditions:
■ Programming equipment that will be used and its extension jack
assignment
■ Mode of operation
■ Language choice
■ Enable and disable Automatic Maintenance Busy
■ A reminder to set the system date
■ Backup schedule
■ Identifying system console extensions
■ Second Dial Tone Timer
■ Identifying system applications
Forms Needed
Form 1, System Planning
Programming Equipment 2
Two types of equipment can be used for system programming:
■ An MLX-20L telephone identified as a system programming console. The
telephone is connected to the first (lowest) extension jack (which is
factory-set for system programming) on the first MLX module.
■ A personal computer (PC) with System Programming and Maintenance
(SPM) software. The PC connects to the lowest jack on the processor
module.
Planning Form Instructions
1. Under the Programming Equipment heading in the System Operating
Conditions section on Form 1 (page 2), do
one of the following:
■ If the system will use a system programming console, check System
Programming Console. Proceed to Step 2.
■ If the system will use a PC with SPM software, check the PC with
SPM Software box and skip to the next section, ‘‘
System Mode’’.